Digital Temperature Controller for 110V/220V (Chinese Version)

*** Due to an error from our supplier we got sent chinese version controller. These are on sale until we receive the english version controller.

These digital temperature controller will let you set and forget your dye tank heating step. They also have a really straight forward wiring with a powerful 10 Amp internal relay. They have mounting tab on each side for convenient installation. They come pre-wired with a NTC Temperature Sensor. A bright LED on the front panel will let you know whenever they are active.

The Black and Red wire are the power input; Connect to any 110V or 220V AC source. When the controller output is active, the Black and Yellow wire are energized. Connect your heating element directly to the Black and Yellow wire. We stock 110V/400W cartridge heater element for tank mounted application. You can see them here.

Specifications;

• Adjustable from -50* to 110* Celcius (Cannot be set to Farenheit)
• Selectable between heating and cooling mode
• 110V or 220V input (match to your heating element)
• 10A / 1500W Internal Relay Capacity (We would not exceed 1200W continuous on these)
• No Instruction Included

How to use the controller;

Wiring;
Black and Red wire; This is the AC Input. Connect to any 110V/220V AC Source. Note that you need to match your heating element voltage.
Black and Yellow wire; This is the AC output power to your heating element. If you need to drive more than 1200W of power, use a Solid State Relay in between.
NTC Sensor; This sensor is pre-wired. If you need to cut the wire to make it longer or to replace a depleting sensor don’t worry about the wire getting mixed, it will work wired either way. Keeping the sensor outside of the dye tank when not in use will extend its lifetime.

Programming;
There is 4 preset that you can set inside the controller. To change any of them, press the SET button once (the button with chinese character) and use the arrow to select the preset number you want to adjust, then press the SET button again. Once you have scrolled to your desired value, press SET again and/or wait 3~5sec for the controller to show the actual temperature. This will store any change you just made.
P0 Start Temperature, adjustable from -50* to 110*C
P1 Stop Temperature, adjustable from -50* to 110*C
P2 Temperature Correction Factor, adjustable from -10* to 10*C
P3 Start Delay, adjustable from 0-10min

Note;
If you need your dye to be at 60*C, set P0 to 58*C and P1 to 60*C. The controller will cycle on and off between 58* and 60*.

If you want to restore factory parameter, hold the UP and DOWN arrow until the display show 888